- Double click on My Computer
- Double click on Control Panel
- Double click on Network Services
- If
Remote Access Service (RAS) is not installed, press Add and then
double-click on Remote Access Services-RAS should now be in the list of
installed services
- Double click on Remote Access Service. If no modems are
listed, press Add and then select your modem from the drop down list
- Click once on your modem to select it
- Click the Configure button
- Select Dial Out only and press OK
- Double click on Network
- For outgoing calls, make sure that you have TCP/IP enabled,
and then press OK
- Click the Continue button.
- Click the Close button. At this point, you will be prompted
to Restart your Computer. If so, select YES to reboot.
- After your computer comes back up double click on My
Computer, then double click on Dial Up Networking.
- If there are no phonebook entries, then press OK when
prompted, otherwise press New to add a new entry.
- In the Entry name, type "PCINW".
- Enter one of the following telephone numbers from POP
Locations and Numbers.
- Click
on Server. The Dial-Up Server Type should be PPP. TCP/IP should be
checked. IPX/SPX and NetBEUI should be unchecked. Enable software
compression and PPP LCP Extensions should be ON.
- Find
Script and set to None. Find Security and set it to Accept any
authentication including clear text. Find X.25 and set it to None. Now
click the OK button.
- Now double click on Dial
- Enter your username in lowercase. eg. bobroony
- Enter your password (case sensitive): eg: actor
- Make sure the domain field is blank
- Click the OK button.
- Open IE or Netscape to "Browse the internet
|